2
Wireless DA-600 and DA-605 Drive-Alert Control Panel Installation Guide
The Mier Products’ Wireless Drive-Alert Detection Systems give you the benefit of easy and economical wireless installation.
These
Systems includes 4 components:
1.
Control Panel/Receiver with Additional Form C Dry Contacts
2. Sensor/Transmitter
3.
Alert Sound Annunciator
* The DA-600 contains an internal piezo whistle
* The DA-605P with integrated DA-066MP wireless chime
transmitter sends a signal to DA-078 plug-in chimes
4.
UL Listed switching mode power supply, isolated from
ground, with input voltage of 100 to 240 50/60HZ, which
provides better lightening rejection. Output regulation of
24VDC +/- 0.5A with output short circuit protection with current limit until fault is cleared.
DA-600 and DA-605 Control Panel/Receivers feature:
• UL Listed 110 volt AC plug
• +24 volt DC power source for use with accessories
• Relay output available for use by accessories
• Visible POWER LED to monitor power status and LO BATT LED to monitor Transmitter batteries
• User accessible address switches to set a unique address code between the Control Panel/Receiver and the Sensor/Transmitter
• Normal reception to 1000 feet, or ½-mile if using the DA-660 Booster Antenna (see Options For Long Range Installations page)
• Use of an unlimited number of Mier Wireless Transmitters by a Control Panel/Receiver
• 100% compatibility with the Mier DA-610TO, optional DA-611TO, and optional DA-612TO Sensor/transmitters
• Compatible with Mier Accessories detailed in this manual (See Accessories Page)
EASY INSTALLATION IS OFTEN COMPLETED IN UNDER 30 MINUTES!
Plug-In
the
Plug-In
or
Place
the Place
the
Sensor-
Control
Panel Chime
(DA-605
Systems)
Transmitter
outside
Installation Guide
FIRST, test the equipment by:
1. Plugging in the Control Panel
2. Turning the Whistle Switch ON if you have a DA-600, or plugging in DA-078 Chime if you have a DA-605
3. Install two (2) AA Lithium batteries in the Sensor/Transmitter, observing polarity, and turn it on in the same room as the Control
Panel/Receiver. Turning on the Sensor/Transmitter will send a signal to the Control Panel/Receiver for about 15 seconds. The
VALID XMSN LED should turn on on the Control Panel/Receiver, and the audible alert should respond. If the Sensor/Transmitter
is moved after a one minute interval, the Control Panel/Receiver will be triggered again. (ex: walking while carrying the Sensor)
Once testing proves the units are communicating correctly, proceed to the following pages to learn how to:
• Properly mount the Control Panel
• Properly place the Sensor/Transmitter in the area you wish to monitor
• Properly place the chimes on a DA-605
• Test the installation
• Add accessories or long-range options
DA-600
DA-605
