Miele WXF 660, Operating Instructions Manual

Page: 96 / 104

Settings
96
Low water pressure
If the water pressure is below 100 kPa
(1 bar), the washing machine cancels
the program and the
Water intake. See
 fault message appears.
If the on-site water pressure cannot be
increased, activating this function will
prevent the program from being
cancelled.
Low water pressure is deactivated as
standard.
Anti-Crease
The Anti-crease function reduces
creasing after the end of the program.
At the end of the program, the drum
continues to turn at intervals for up to
30 min. The washing machine door can
be unlocked at any time by touching the
Start / Add laundry sensor button and
then opened.
Anti-crease is activated as standard.
Miele@home
Control the networking of your
washing machine with your WiFi
network.
The following points may appear in the
sub-menu:
Set up
This message only appears if the
washing machine has not yet been
connected to a WiFi network.
Please refer to “Before using for the first
time” for instructions on how to set up
the connection.
Deactivate (visible if Miele@home is
activated)
Miele@home remains set up; the WiFi
function is turned off.
Activate
(visible if Miele@home is
deactivated)
The WiFi function is reactivated.
Connection status (visible if Miele@home
is activated)
The following values are displayed:
- the quality of WiFi reception
- the network name
- the IP address
Set up again
(visible if set up)
Resets the WiFi login (network) to
immediately re-establish a new
connection.
Reset (visible if set up)
- The WiFi is switched off.
- The WiFi connection will be reset to
the factory setting.
The network configuration should be
reset whenever a washing machine is
being disposed of or sold, or if a used
washing machine is being put into
operation. This is the only way to
ensure that all personal data has been
removed and the previous owner will no
longer be able to access the washing
machine.
A new connection setup has to be
carried out in order to use the
Miele@home setting again.