This machine is for use only with articles
which have not been treated with danger-
ous or flammable substances.
To prevent frost damage do not install this
machine in a room exposed to frost.
It is essential that the machine is level, and
secured (see Installation diagram supplied).
The machine must not be moved without
all the outer panels in place.
Shipping struts
Once the machine has been set in its final
position the red-marked shipping struts
must be removed. Ensure they are re-
moved before using the machine.
^
The red-marked shipping struts "
A
" on the
diagram, 2 at the side front and 2 at the
side rear are each fixed with 3 M 10
(SW 17) hex screws. Remove these.
The red-marked shipping struts "
B
" on the
diagram, 2 at the front and 2 at the rear are
each fixed with 3 M 10 (SW 17) hex screws.
^
To remove them detach the front service
panel and the rear panel. Unscrew the 3
M6 hex screws (SW 8) at the bottom edge
of the front service panel, and take it off.
Unscrew 8 hex screws in the rear panel
and remove.
The plinths for the front and rear panels are
secured with the rear panel, and should be
fitted when the machine has been installed.
The screws are found in the pre-drilled
holes.
The shipping struts should be stored in a
safe place for future use. They must be re-
fitted if the machine is moved.
Installation
33
