4. Remove the laundry
30
End of programme/Anti-crease
Programme end:
lights up and the
Start/Stop
sensor goes out.
Following the end of the programme,
the Anti-crease phase is activated for
max. 2 hours. There is no Anti-crease
phase with
Woollens handcare
.
See “Programmable functions”, “
Anti-crease”.
Energy saving:
– 10 minutes after the end of the pro-
gramme, the
Start/Stop
sensor will
begin to flash and the display will go
out.
– The dryer will switch off automatically
15 minutes after the end of the anti-
crease phase (with programmes
without an anti-crease phase it will
switch off 15 minutes after the end of
the programme).
Unloading the drum
Only open the door when the drying
process has finished. Otherwise, the
laundry will not be properly dried
through and cooled down.
Pull the door open at the side with
the orange marker.
Remove the laundry.
Items left in the dryer could be dam-
aged by overdrying when the dryer is
used the next time.
Always remove all items from the
drum.
Turn the programme selector to the
position.
Remove the fluff from the 2 fluff filters
in the door opening: see “Cleaning
and care - Fluff filters”.
Shut the door with a gentle swing.
Empty the condensed water con-
tainer.
We recommend that you drain the con-
densed water externally through the
drain hose when drying a full load using
the
Cottons
and
Cottons
pro-
grammes. This will avoid having to
empty the condensed water container
during the programme.
