– 9 –
BLOCKAGES - UNPLUG THE MACHINE FROM THE WALL
MAINTENANCE FOR THE BEATER BAR
DO NOT USE YOUR FINGERS OR HANDS
TO REMOVE OR CLEAN THE BEATER BAR.
When it is necessary to remove thread, string, hair,
etc., which has wound around the beater bar, cut
across them with a pair of scissors making sure not
to cut the brush.
ON
BEATE
BAR
STO
Suction
pipe inlet
Top
suction inlet
TROUBLE SHOOTING GUIDE
Before returning the vacuum cleaner to a Miele Service Center, check the following points:
TROUBLE
CHECK POINT
CAUSE / REMEDY
Motor fails to rotate
• Mains plug connection.
• Mains plug is connected firmly and
(no noise is heard at all).
mains outlet is ON.
Motor runs but no suction.
• Hose inlet is blocked.
• If there is clog, remove it.
• Check the bag change indicator. • If shows full, replace the paper bag.
• Paper bag broken or clogged.
• If the paper bag is broken, replace it.
• Central filter.
• If the central filter is full of dust, clean
or replace it.
Beater bar does not rotate.
• Beater bar / blocked.
• If there is an obstruction, remove it.
• Belt broken or loose.
• If belt is broken replace it. If loose
re-install it again.
If your vacuum stops picking up dust, or the Bag Change Indicator shows “Full” while the dust
bag is still empty, a blockage may have occurred.
To remove the obstruction, proceed as follows:
Remove the hose from the top suction inlet by pushing the two small clips in turning the hose to the right
and pulling it out (Fig. 1). Clear any obstruction from the hose or top suction inlet using a blunt implement,
taking care not to damage the hose.
If the obstruction occurs in the suction pipe inlet, it can be removed as shown in Fig. 2.
Fig. 1
Fig. 2
M.I.MIELE S179i 11/6/03 08:53 Página 9
