Some models are equipped with an
exhaust filter reset button (see fig.
28). This button indicates when to
change the Active Air Clean filter
and the Active HEPA filter. If an Air
Clean filter is used, the reset button
can be disregarded. The Air Clean
filter should be changed whenever a
new box of Miele FilterBags is
opened. The indicator goes out
when the reset button is pressed.
Removing hair and threads from the
Powerbrush (see fig. 34)
^
Turn off the vacuum and unplug it
from the outlet.
^
Release the body of the vacuum
cleaner and lower it to the floor (see
fig. 9).
^
Turn the vacuum cleaner over.
^
Use scissors to cut any threads or
hair that have wound around the
roller brush. Guide the scissors along
the guide track on the beater bar.
The trimmings will be drawn into the
vacuum cleaner by the suction once
the vacuum cleaner is turned on.
Blockages (see fig. 35 + 36)
If there are large particles or other
blockages at the base of the suction
hose, you can open it up to clear the
passage.
^
Click the vacuum cleaner into the full
upright position.
^
Press the release button on the
telescopic wand and remove the
handle from the suction hose
^
Guide the swivel elbow at the end of
the suction hose over the catch
hooks, to increase the stability the
vacuum cleaner (see fig. 18).
A
Undo the suction hose in the
direction of the arrow.
B
Pull the suction hose connector off
the swivel elbow.
^
Remove all blockages
^
Put the connector back on and click
it shut.
If you still have not been able to remove
the obstruction(s), there is another
method you can try.
Open the service flap on the bottom
rear of the vacuum cleaner.
A
Use a coin to undo the two screws
until they stop.
B
Pry the service flap free.
^
Remove all blockages.
Put the service flap back on and screw
into place.
Cleaning and care
Cleaning
,
Turn the vacuum cleaner off and
unplug it from the outlet before
performing any maintenance work.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic
accessories can be cleaned using a
damp cloth and a cleaner suitable for
plastics.
en
17
