Supervisor level
80
Programme packages
The selection of programmes can be
extended by activating single
programmes from the programme
packages.
The programmes selected from the
programme packages are displayed
under
Further programmes
.
– Standard
– Pre-treat mops
– Pre-treat cloths
– Ready to use
– Workwear
– Standard programmes
After selecting the programme
packages, the individual programmes
from the list are activated (activated
programmes are marked with a frame).
The selection must then be confirmed.
Disinfection prog. code
A code needs to be entered to cancel
a disinfection programme. The code
can be changed.
The code is:
0 0 0
Useful tip:
Make a note of your new
code if you ever change it.
Auto load control
The washing machine is equipped
with an automatic load control. In
some programmes, the water levels
and the programme cycle times are
adapted to the load. If the automatic
load control is deactivated, the
machine will always carry out the
programme sequence based on a full
load.
Factory setting: On
Automatic dispensing
Automatic dispensing via an external
dispensing system can be activated.
Factory setting: Off
Peak load signal
The peak-load cut-off function
enables the washing machine to be
connected to an energy management
system. When a signal is registered,
the washing machine's heater is
switched off for a short period. The
washing machine may only be
operated with a peak-load system if
this system is connected to the
washing machine via the Miele XCI
box.
– No function (factory setting)
– Peak load with 230V
– Peak load with 0V
