Electrical connection must comply with national regulations.
Connection using multi-pole lockable wall socket in
compliance with IEC/EN 60309 and IEC/EN 60947 is
recommended in order to simplify electrical tests. If machines
are hard-wired, a multi-pole mains switch must be provided
on site. Switches with a contact gap of more than 3 mm can
be used. These include switches, fuses and contactors
(IEC/EN 60947). A wall socket or mains isolator must be
easily accessible after installation.
Reinstallation of the supply point, changes to the equipment
or checks on the protective conductor, including determination
of correct fuse rating, should only be performed by a properly
trained electrician.
If necessary, equipotential bonding with good galvanic contact
must be provided in accordance with all appropriate national
and local regulations.
Vented
Nominal air throughput in vented mode
188 cfm
320 m³/h
Max. permissible pressure loss
0.06 psi
420 Pa
Waste air/gas temperature, max.
176°F
80°C
Connector on machine (int. diameter)
3 15/16
''
100 mm
Connection pipe provided on site (ext. diameter)
3 15/16
''
100 mm
Miele adapter, Mat. no. 6595070 (int. diameter 100 mm) for
flexible aluminum ducting and adapter, Mat. no. 915051, (ext.
diameter 110 mm) for connection to standard heat-resistant
plastic pipes supplied.
As relative humidity inside the vent ducting can be as high as
100%, suitable measures must be taken to prevent a
backflow of condensate into the machine.
Air intake
Standard connection:
=> Air intake from installation site
Min. air intake cross-section
(to prevent draughts in room)
37 in
2
237 cm
2
A sufficient supply of fresh air should be ensured to replace
the air extracted.
Fittings for base
/ floor
installation
5/16
''
x 2 9/16
''
8
mm
x
65 mm
1/2
''
x 2 3/8
''
12
mm
x
60 mm
Miele base UG/UO 6008
4 × metal angled brackets
(to secure machine to base)
4 × screws DIN 571 (Ø × length)
4 × rawl plugs (Ø × length)
Base must be bolted to the floor. Machine must be fixed to the
base. Fixing materials for a floating screed floor are to be
provided on site.
1/4
''
x 2
''
6
mm
x
50 mm
5/16
''
x 1 9/16
''
8
mm
x
40 mm
Miele US 6008 base
4
x
metal angled brackets
(to secure machine to base)
4 × screws DIN 571 (Ø × length)
4 × rawl plugs (Ø × length)
Base must be bolted to the floor. Machine must be fixed to the
base. Fixing materials for a floating screed floor are to be
provided on site.
1/4
''
x 2
''
6
mm
x
50 mm
5/16
''
x 1 9/1
6''
8
mm
x
40 mm
Installation on floor or concrete base
2 × clamps
2 × screws DIN 571 (Ø × length)
2 × rawl plugs (Ø × length)
Machine must be fixed to the base or floor. Fittings are
supplied with machine. Fixing materials for a floating screed
floor are to be provided on site.
Technical datasheet: PT 7186 EL (Electric
ally Heated
)
Date:
2015-04-29
Page: 12
