Before the washer is used for the
first time, it needs to be properly
installed and connected. See
"Installation and connection".
Because the washer was put through
a complete operational test in the
factory, there will be some water left
in the drum.
For safety reasons, the washer will not
spin until it has been prepared for use.
To activate the spinning function, you
will need to run a wash programwithout
laundry and without detergent.
If you use detergent, it will cause
excessive sudsing.
This preparation step also activates the
ball valve in the drain. Once activated,
the ball valve helps prevent detergent
escaping from the suds container into
the drain during a wash program, thus
ensuring maximum use of the
detergent.
^
Press the
I-On/0-Off
button in.
If the washer is being switched on for
the first time, the welcome screen will
appear.
The welcome screen will appear in
the display every time the washer is
switched on, until a program lasting
longer than 1 hour has been
completed.
Setting the language
You will be prompted to select the
desired display language. You can
change the language at any time
through the programmable functions.
!
deutsch
^
Turn the program selector to select
the desired display language. Use
the
Start/Stop
button to confirm your
selection.
Reminder to remove the shipping
rods
The shipping rods must be removed
before the washer is used for the
first time, to help prevent damage to
the appliance.
^
After removing the shipping rods,
press the
Start/Stop
button.
Running the washer for the first time
Run a
Cotton 60°C
with no laundry and
no detergent. (This program is
automatically selected.)
^
Open the faucets.
^
Press the
Start/Stop
button.
^
Once the program is finished, switch
the washer off.
The washer is now ready for regular
use.
Before using for the first time
12
