Miele KM 530, Operating And Installation Instructions

Page: 31 / 72

Stop and Go
Your appliance has a Stop and Go
feature which, when activated, reduces
the power of all cooking zones that
have been switched on. This allows you
to leave the hob unattended for a short
time without any danger of pans boiling
over or burning.
If you wish to use this feature, you will
need to alter the factory setting (see
"Programming - P5").
To activate Stop and Go:
^
Touch the
$
sensor until you hear
two consecutive beeps.
Be careful not to continue touching
the
$
sensor for too long, as this will
activate the safety lock.
The indicator lamp for the safety lock
will start to flash. The power of the
cooking zone in use will be reduced to
setting 1, and a
1 will appear in the
corresponding cooking zone display.
If automatic switch-off is programmed
for a cooking zone, activating Stop and
Go will interrupt the count down to the
switch-off time. When Stop and Go is
deactivated, the automatic switch-off
programme time will continue to run
without further interruption.
If a minute minder time has been set,
this will continue running and will not be
affected by Stop and Go.
To deactivate Stop and Go:
^
Touch the safety lock sensor
$
until
the indicator lamp goes out.
The cooking zones will now run at the
level that was previously set.
Safety features
31