^
Position wide brackets
j
at the top
and bottom on the back, and push
the top bracket upwards until it is in
the correct position (z).
^
Secure the brackets at the sides
using hex screws
k
supplied.
Do
not
drill holes for these screws in the
appliance.
To avoid vibrations, neither the
brackets nor the screws should
touch the pipework on the backs of
the appliances.
^
Connect both appliances to the
electricity supply as described under
"Electrical connection".
^
Carefully push the two appliances
back into their final position. It is
easier if you raise the appliances at
the front, and roll them back on their
rear rollers.
The height of the appliances can be
aligned again if necessary.
^
Position the long stainless steel trim
l
in the gap, making sure that it is
located above bracket
e
.
Pressing both ridges along the trim
together as you do so makes it
easier to fit the trim into the gap.
^
Carefully work the stainless steel trim
into the gap. Use a soft cloth to do
this to avoid denting the trim.
^
Carefully remove the protective foil
from the stainless steel trim.
Installing in a side-by-side combination
63
