^
Secure the appliance in the housing
unit using the short 4 x 14 mm
screws
b
through the bottom hinge
plates and then tighten them up.
^
Screw fixing bracket
e
back on (if
this has not already been done).
^
Secure the appliance to the housing
unit wall on the door opening side
using two 4 x 14 mm screws through
the upper fixing bracket
a
and one 4
x 14 mm screw
f
through fixing
bracket
e
and then tighten them.
^
Close the fixing bracket
a
back up
again and fit cover
g
.
^
Align cover strip
h
by sliding it
parallel to the housing unit ceiling.
The cover strip must not protude.
^
Secure the appliance to the top of the
housing unit using the short 4 x 14
mm screws
i
through the cover strip
before tightening them.
Fitting a furniture door
^
Fit the door coupling parts
a
to the
appliance door at handle height
using the 3.9 x 9.5 mm self tapping
screws
b
(on a larger door an extra
door coupling should be fitted). Use
the pre-drilled holes.
^
Open the doors right out and push
the coupling guides
c
into the door
coupling parts.
Building in the appliance
44
Summary of Contents for KF 888 iDN-1
Page 46: ...46 ...
Page 47: ...47 ...
Page 48: ...Alteration rights reserved 1905 KF 888 iDN 1 M Nr 05 910 970 05 en GB ...
