![background image](http://html.mh-extra.com/html/miele/kf-888-idn-1/kf-888-idn-1_operating-and-installation-instructions_236529043.webp)
Building in
^
Push the appliance into the niche.
Make sure that the mains cable does
not get trapped.
^
Screw fixing bracket
a
back on (if
this has not already been done).
^
Push the appliance up against the
housing on the door opening side
(
A
), so that the sealing strip is
pressed against it.
^
Then push the appliance into the
niche until the front edge of the hinge
plates are flush with the housing unit
floor (
B
), and the front edge of the
opened fixing bracket
a
is flush with
the housing unit.
A gap of 43 mm must be maintained
between the appliance and the
housing unit on the hinge side.
(Marked X on the drawing)
^
Secure the appliance on the hinge
side to the housing unit at the top
and in the middle on
19 mm thick housing unit walls
by
using the shorter 5 x 75 mm screws
c
and the smaller spacer sleeves
d
,
and on
16 mm thick housing unit
walls
by using the longer 5 x 80 mm
screws
c
and the longer spacer
sleeves
d
.
Building in the appliance
43
Summary of Contents for KF 888 iDN-1
Page 46: ...46 ...
Page 47: ...47 ...
Page 48: ...Alteration rights reserved 1905 KF 888 iDN 1 M Nr 05 910 970 05 en GB ...