^
Pull bearing bush
d
downwards out
of hinge bracket
e
and refit it from
above into the hinge bracket.
^
Use a screwdriver to remove spacer
g
and refit it on the opposite side.
Changing over the door handle:
^
Remove covers
m
at the front and
slide off to the side.
^
Unscrew handle
k
. Refit handle and
stoppers
l
on the opposite side.
^
Slide covers
m
into position making
sure they engage correctly.
Refitting the doors:
^
Remove plugs
j
from door bearing
bushes in the doors and refit on the
opposite side.
^
Hang the upper appliance door on
hinge pin
c
, and close the appliance
door.
^
Push middle hinge pin
f
from below
through hinge bracket
e
into the up-
per appliance door.
^
Check that the door is correctly
aligned. If necessary align it using
the long slots in hinge bracket
e
.
^
Hang the lower door in hinge bracket
e
then close the appliance door.
In the following illustration the lower
door is not shown in the closed posi-
tion to make it easier to see what
happens next.
^
Turn door support
b
around, pull
hinge pin
a
out, and refit on the op-
posite side.
^
Fit both parts into hinge plate
f
. To
do this push hinge pin
a
through
hinge plate
f
into door support
b
.
Swing door support out, push up-
wards and re-assemble with screw
c
.
^
Align the lower door with the appli-
ance housing using the long slot in
hinge plate
f
. Then tighten screw
c
.
^
Refit plinth fascia
d
pushing it firmly
into position.
^
With the lower door open, secure
cover
e
to the front of the plinth fas-
cia.
Changing the door hinging
39
