11189580-08
Installation
*INSTALLATION*
Electrical connection
Danger of injury!
Miele cannot be held liable for
unauthorised installation,
maintenance and repair work as this
can be dangerous to users.
Connection to the electrical mains
may only be carried out by a
qualified electrician in accordance
with national and local regulations
and the additional regulations of the
local electrical supply companies.
Connection of this appliance must
comply with national and local safety
regulations.
Connection to a switched socket
is
recommended as this provides easier
access in the case of a service call.
If the appliance is
hardwired
or if the
switch is not accessible after
installation, an additional means of
disconnection must be provided for all
poles.
Suitable means of disconnection
include switches with an all-pole
contact gap of at least 3 mm. These
include isolator switches, fuses and
relays.
Voltage, rated load and fuse rating
are given on the data plate situated at
the front of the oven compartment.
Please ensure the connection data
matches the household supply.
When contacting Miele, please quote
the following:
- Model number
- Serial number
- Connection data (voltage/frequency/
maximum rated load)
If the mains connection cable is
damaged, it must be replaced by a
suitably qualified electrician with a
specialist connection cable of type
H 05 VV-F, available from Miele, in
order to avoid a hazard.
Temporary or permanent operation with
a self-sufficient or non-mains
synchronous energy supply system
(e.g. isolated networks, back-up
systems) is possible. A requirement for
the operation is that the energy supply
system complies with all current local
and national requirements that apply to
stand-alone, solar and/or battery
systems.
The protective measures provided in
the domestic installation and in this
Miele product must also be assured in
their function and operation in isolated
operation or in non-mains synchronous
operation, or replaced with equivalent
measures in the installation.
Wiring diagram
N.B. This appliance is supplied
single phase only in AUS/NZ.
The appliance must only be
connected in accordance with the
options below which include a
neutral conductor (see wiring
diagrams in thick-framed box). The
two connection options below the
thick-framed box are not permitted in
AUS/NZ.
