Thermal cut-out
This machine has a resettable heater
limiter which will shut off the elements in
the event of over-heating. This could be
caused, for example, by large articles
covering the heating elements or if the
filters in the wash cabinet are blocked.
If the fault code:
F01 - F03
,
F18
,
F19,
F27
(water was not heated up in the
wash cabinet and the programme is
taking too long) shows in the display,
proceed as follows:
^
Remove the cause of the fault.
^
Remove the service panel.
^
Press the reset button on the heater
limiter located on the right-hand side
of the plinth.
If this switch trips again, contact the
Miele Service Department.
Other problems
67