Salt indicator.
When the salt reservoir is empty, the
“Salt
9
” indicator lamp will light, not-
ifying you that the reservoir should be
refilled with reactivation salt.
After the reservoir has been filled, the
water softener is automatically reacti-
vated the next time the dishwasher is
run.
The “Softener” indicator lamp illumi-
nates during this process.
Note:
If your water is very soft (below
7 gr/gal), the salt indicator lamp will
stay on. In this case the reservoir
should not be filled with salt. The indica-
tor lamp will remain lit and should be
disregarded or bypassed.
The “Salt
9
” indicator lamp has also
been designed for future program up-
dates (PC). See the “After Sales Ser-
vice” section for further details.
Bypassing the Salt indicator lamp.
In order to bypass the salt indicator
lamp, you will need a screwdriver and
needle nose pliers.
Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side
b
.
Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
Using the needle nose pliers, first
pull the cap
c
off of the float cham-
ber, then remove the float
d
.
Replace the float chamber cap,
push the chamber back into its up-
right position, and replace the salt
reservoir cap. The indicator lamp
should now remain off.
Water Softener
19
