Increasing the water intake
time
If the water pressure is lower than 1.0
bar, too little water will flow into the
wash cabinet (see “Checking the water
level”). In this case the water intake
time must be increased.
Proceed as follows:
Switch the dishwasher off using the
“On/Off” button.
Turn the programme selector to
“Stop”.
Press the “Top Solo” button in and
whilst doing so at the same time
switch the dishwasher on using the
“On/Off” button. Release the “Top
Solo” button again within two
seconds.
The “Salt” indicator light will start flash-
ing
Note:
If a different indicator light is on or flash-
ing, the process must be repeated.
Exception:
The “Rinse aid” indicator light will come
on if you have not yet added rinse aid
or if rinse aid needs replenishing.
Turn the programme selector to the
“Economy 45°” setting.
– If the “Top Solo” indicator light does
not come on, then the water intake
time is set to the standard time,
– If the “Top Solo” indicator light
comes on: then the water intake time
is set to increased intake time.
Press the “Top Solo” button to
change the setting.
Depending on the previous setting, the
“Top Solo” indicator light will either
come on or remain switched off.
Turn the programme selector to the
“Stop” position.
Switch the dishwasher off using the
“On/Off” button.
The modified water intake time is now
stored in memory.
Solving problems
51