Drying heat
In all programmes the drying process is
assisted by the heating element. Drying
heat is set as activated at the factory.
Switching the heating elements off dur-
ing drying will save approx. 0.1 kWh in
electricity. The dishes are then dried
with residual heat. Open the dish-
washer door at the end of a programme
to allow the dishes to dry better.
Activation/Deactivation of drying
heat
^
Switch the dishwasher off using the
"On/Off" button.
^
Turn the programme selector to the
"Stop" position.
^
Press the "Start" button in and whilst
holding it in switch the dishwasher
on using the "On/Off" button. Release
the "Start" button within two seconds.
The "Salt" indicator light will start flash-
ing
Note:
If a different indicator light comes on or
flashes, the process must be repeated.
Exception:
The "Rinse aid" indicator light will come
on if you have not yet added rinse aid
or if rinse aid needs replenishing.
^
Turn the programme selector to the
"10 o’clock" position.
– If the "Start" indicator light does not
come on:
Drying heat is switched on.
– If the "Start" indicator light does
come on:
Drying heat is switched off.
^
Press the "Start" button to change the
setting.
Depending on the previous setting the
"Start" indicator light will either come on
or go out.
^
Turn the programme selector to the
"Stop" position.
^
Switch the dishwasher off using the
"On/Off" button.
The change is now stored in memory.
Operating the dishwasher
34
