To call up the water hardness
level in the display
After your dishwasher has been
through one programme cycle (e. g.
Pre-wash), you can check the water
hardness level measured by the water
softener sensor in the display.
This is shown in °d - German scale, and
can fluctuate depending on the quality
of the water.
^
Switch the dishwasher off with the
On/Off button
s
.
^
Press the Start/Stop button in and
whilst holding it in
switch the
dishwasher on using the On/Off
button
s
.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Delay start button six times.
The "Delay start" indicator will flash
briefly six times at intervals.
The number after the
p
in the display is
the water hardness level in °d (see
chart).
^
Switch the dishwasher off with the
On/Off button
s
.
°d
German
scale
mmol/l
°f
Value displayed
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37-50
51-60
61-70
0.2
0.4
0.5
0.7
0.9
1.1
1.3
1.4
1.6
1.8
2.0
2.2
2.3
2.5
2.7
2.9
3.1
3.2
3.4
3.6
3.8
4.0
4.1
4.3
4.5
4.7
4.9
5.0
5.2
5.4
5.6
5.8
5.9
6.1
6.3
6.5
6.7-9.0
9.2-10.8
11.0-12.6
2
4
5
7
9
11
13
14
16
18
20
22
23
25
27
29
31
32
34
36
38
40
41
43
45
47
49
50
52
54
56
58
59
61
63
65
67-90
92-108
110-126
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
50
60
70
Before using for the first time
14
