... after moving house the appliance
no longer switches from the
heating-up phase to the cooking
phase.
Altitude affects the boiling point of
water. The appliance must be reset to
take into account the different water
boiling point in its new location (see
"Cleaning and heating up for the first
time".)
... during operation an unusually
large amount of steam escapes or
steam escapes from parts of the
steam oven where it does not
usually.
Check whether
– the door is closed properly.
– the door seal is fitted correctly. If
necessary, press it in all the way
round the door to make sure it is
fitted evenly.
– the door seal is damaged, e.g.
cracks can be seen. The seal must
be replaced with a new one.
If this does not solve the problem, call
the Miele Service Department.
... a whistling sound is heard when
the appliance is switched on again.
When the door is closed, the pressure
has to equalise, which can cause a
whistling sound. This is not a fault.
....
F
and a number appear in the
display.
This combination indicates a fault.
– F 20: The appliance does not heat
up.
First of all, check whether the steam
generator has been pushed right into
the appliance so that it connects.
Then switch the appliance off and
then back on again.
If the fault occurs again, lightly
lubricate the coupling seal on the
steam generator with silicone grease,
as described in "Coupling seal".
If the appliance still will not start,
switch it off and contact the Miele
Service Department.
– Other fault messages:
Call the Service department.
Problem solving guide
68
Summary of Contents for DG 4050
Page 79: ...79 ...
Page 80: ...Alteration rights reserved xx06 M Nr 06 159 580 04 en ...