Umbau- und Montageanweisung
M.-Nr. 09469886
37 von 86
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
28.09.2018
The eccentric cams may move slightly when their screws are loosened. To ensure safe installation, the eccentric cams
must be returned to the starting position: Engaging tooth in the bottom left at a 20° angle (1); see Fig. 7.
A
Use 1 CEM 4 x 10 raised-head screw to install the rear panel on the stand at the bottom (2); see Fig. 7.
A
Hook the connection pieces (3) onto the screws on the eccentric cams; see Fig. 7.
A
Use 2 CEM 4 x 10 raised-head screws to install the connection pieces and the rear panel on the stand at the top (1);
see Fig. 8.
A
Tighten the screws on the eccentric cams (2); see Fig. 8.
A
Level the machine and stand using a spirit level.
A
Counter the stand feet.
A
Secure the stand to the floor with the floor fastening kit, mat. no. 06593051.
Installing the stand under the washer
Before the actual assembly, the connection pieces are secured on the stand. They are used to connect two stands
securely together. Tighten the connection pieces even if a second stand is not to be used. This will avoid possibly
difficult retrofitting and also ensures that the connection pieces are stored safely.
Installation of dryer on left and washing machine on right: See Fig. 9.
Installation of dryer on left and washing machine on right: See Fig. 10.
A
Use a pipe wrench to hold the threaded bolts in the stand and remove the stand feet.
A
Unscrew two stand feet from the left or right side, depending on the installation setup; see Fig. 9 or Fig. 10.
A
Install the washers on the drip pan; see Fig. 9 or Fig. 10.
A
Install the connection pieces (1) on the washers; see Fig. 9 or Fig. 10.
A
Screw on the stand feet but don't secure them with the counter nuts yet.
NOTE
Damage to washer and carpeting.
A
Drain all water out of the washer.
A
Remove the dispensing assembly.
A
Install the washer's shipping struts
before tilting the washer on its side.
A
The washer must be laid on a flat, soft underlayer (e.g., a carpet).
A
Install the shipping struts; see the operating instructions.
A
Lay the washer on its side.
A
Unscrew and remove the washer feet.
A
Install the spacer sleeves (1) on the set screws; see Fig. 11.
A
Stick the stand and the washer together.
A
Tighten the bolts inside the stand with an open wrench. Tighten the bolts alternately to ensure even tightening.
A
Stand the washer/stand assembly upright.
A
Install the sealing strips as shown on the inside of the rear panel; see Fig. 6.
A
Use 3 CEM 4 x 10 raised-head screws to install the rear panel on the stand; see Fig. 12.
A
Level the machine and stand using a spirit level.
A
Twist in the connection pieces on the stand.
A
Counter the stand feet.
A
Secure the stand to the floor with the floor fastening kit, mat. no. 06593051.
