ASSEMBLY INSTRUCTIONS
Place the Carrier Top on a flat surface.
Attach the Strap Hooks in the front and
back, attach one Security Hinge, and attach
the Handle.
Note: The Handle comes pre-attached
on the 24” carrier.
Attach the remaining Security Hinge to the
Carrier Bottom.
When the Security Hinges are in the “open”
position, the door can be opened and will
remain secure when closed. In the “closed”
position, the Security Hinges provide
additional security by adding length to the
space that the door prongs must clear to
open.
Attach four Yellow Buckle Hinges to four
Assembly Buckles by snapping them into
place as illustrated. As an example, one
has been pre-assembled for you.
1.
2.
3.
CORRECT
INCORRECT
Strap Hook
Location
Handle
Security
Hinge
Security
Hinge
Closed Position
Open Position
Strap Hook
Location
Place the Carrier Bottom on a flat surface and
attach the Assembly Buckles. The Yellow Buckle
Hinges will snap into place on the spaces
provided on the Carrier Bottom; keep the
Assembly Buckle and Yellow Buckle Hinge in a
“V” formation while attaching for easiest
application.
Place the Carrier Top on the Carrier Bottom.
Before locking the Buckles, attach the Door by
placing the bottom door prong into the hole on
the left side of the Carrier Bottom. Lift up on the
Carrier Top to insert the top door prong into the
Carrier Top. Lower the Carrier Top so it rests on
the Carrier Bottom and secure them together by
locking the Assembly Buckles.
NOTE: The assembled carrier has multiple
tie-down locations in the corners for use with
plastic ties. This is recommended for air travel.
To Operate the Door, squeeze the orange tabs
to disengage the spring-loaded prongs, then
swing the door open.
4.
5.
6.
“V” Formation
