MIDWEST FASTENERS CD80, Owner'S Manual

Page: 10 / 26

Follow the process below to properly install your CD 80 stud welder.
CD 80 Cable Connections
1. Carefully remove the controller, cables and weld gun from the
shipping packaging.
2. Set the
Controller
on a clean, dry, sturdy surface near an appropriate
voltage supply and the workpiece.
3. Connect the Ground Cable male cam-lok connector to the controller
connector marked “CD / GROUND CABLE.”
4. Clamp the
Ground Cable
C-clamp firmly to a clean (free from paint,
rust, scale, grease or oil) area on the workpiece.
5. Connect the Gun Cable male cam-lok connector to the Controller
receptacle marked “GUN.”
6. Connect the
Gun Cable
control connector to the Controller
receptacle marked “CONTROL.”
7. Plug the Controller Power Cord to appropriate power source.
©2001
MIDWEST FASTENERS, INC.
—
CD 80 Stud Welder 9
CD 80 INSTALLATION
NOTE: All cables should be
laid out straight or in large loops.
Poor welds may result if
welding cables are closely
coiled or stacked up.
Ground
Cable
Weld
Gun
Controller
CD CONTROL GUN
GROUND CABLE