•
11
•
PRINT/VIEW CAPABILITY
IMPORTANT:
When you start a new test by reconnecting to the battery,
all the previous test data in the analyzer’s memory will be erased.
By pressing and holding the
PRINT/VIEW
button after completing a test
and disconnecting from the battery, you will be given the option of
viewing the last test or printing the last test result. If you choose to view
the last test, use the
ENTER
and
BACK
buttons to scroll through the
last result.
The Micro500 also has the ability to print the last test result using the IR
output at the top of the analyzer and the IR receiver at the bottom of the
Midtronics printer (below the
MODE
button). With the printer on, align
the IR output from the Micro500 with the receiver on the printer and
press and hold the
PRINT/VIEW
button. Select PRINT from the option
menu by pressing the up or down
ARROW
button then press the
ENTER
button to make the selection.
HINTS
:
1.
The analyzer will continue to send data once the print button is
pressed. If the analyzer output and the printer input are not aligned,
all the data may not print. If data has not printed, press the
PRINT/
VIEW
button a second time to cancel the print job. Verify alignment
between the analyzer and printer, then press the print button. The
printer will begin printing.
2.
It takes approximately 30 seconds to print the full test results. The
test results are displayed on the screen while they are printed.
Refer to the enclosed printer manual for more information.