MidNite Solar MNROSIE7048M, Owner'S Manual

Page: 6 / 57

MNROSIE7048 MANUAL
6| P a g e 1 0 - 4 3 2 - 1 R E V : -
o
Rosie ’s Class 2 circuits: CANBUS, Batt Temp Sensor; AUX terminals; WBJr terminal.
•
Use insulated tools to reduce the chance of electrical shock or accidental short circuits.
•
Turn off all breakers prior to removing front cover and working on the inside of Rosie.
•
Only qualified service personnel can remove cover, shock hazards are present.
•
The maximum voltage from the printed circuit board to ground is 300VDC.
•
Torque all wiring and cable connections to the required torque values.
•
All unused conduit holes must be filled with a UL listed conduit plug.
•
Use only copper wires with a minimum temperature rating of 90°C.
•
The Rosie is provided with integral protection against overloads.
•
There are no user-serviceable parts contained in the Rosie.
•
Always verify proper wiring prior to starting the inverter.
•
The inverter must be properly mounted.
BATTERY SAFETY
•
Wear eye protection and avoid touching your eyes and face when working with batteries to
keep any fluid/corrosion on the battery from contact with eyes and skin. Have plenty of fresh
There may be a risk of electric shock from energy stored in capacitors.
Wait 5 minutes after disconnecting battery cables before servicing the Rosie.
CAUTION!
To reduce the risk of fire, connect only to a circuit provided with 60 AC amperes and/or
300 DC amperes maximum branch-circuit over-current protection in accordance with
the National Electrical Code, ANSI/NFPA 70 .
CAUTION!
To reduce the risk of fire, do NOT wire the Rosie to an AC load center (circuit breaker
panel) having multiwire branch circuits connected.
WARNING!