BATTERY INSTALLATION
À
When replacing batteries, turn power switch off.
Note:
This transceiver opérâtes from 15 volts DC and may be powered by 12
1.25 volt nickel cadmium rechargable cells or 10 1.5 volt regulär " A A "
type penlight cells. When using penlight cells, 2 dummy batteries (sup-
plied) must be used.
Due to the high current drain of this unit, nickel cadmium or alkaline cells are
recommended.
To replace batteries, loosen the two large slotted screws located on the bottom
and back of the case. (See figure 6)
Carefully disconnect the battery power plug.
Refer to figure 4 for regulär penlight cell installation. Note: Dummy batteries
must be placed as shown.
Refer to figure 5 for nickel cadmium cell installation.
Connect power plug and replace cabinet back.
BATTERY INSTALLATION FOR REGULAR PENLIGHT CELLS
1. USE 10 HEAVY-DUTY
VA
VOLT "AA” ALKALINE BATTERIES AND 2 DUMMY BATTERIES
PLACE 2 DUMMY BATTERIES HERE
12 SERIES-CONNECTED BATTERY CELLS
BATTERY
POWER PLUG
(CONNECTS TO POWER SOCKET IN MAIN UNIT)
FIGURE-4
