Midland G10 instruction guide
| 7
ming software.
To enable the Scan function, all 16 channels must be programmed.
If you turn on the radio on channel 16, the scanning will automatically
start.
Whenever any signal is detected, the scanning will stop on a busy chan-
nel.
If the
PTT
is pressed, you will transmit on the latest busy channel.
Channel 16 is the priority channel
, therefore if you don’t pick up any
signal when you press
PTT
, the radio will transmit on channel 16.
Squelch
The Squelch function suppresses noises on free channels and allows to
receive even weak signals.
G10
has 10 different Squelch levels that can be set by programming sof-
tware: 0 means that the Squelch is turned off; from level 1 to level 9 you
will have different levels of noise reduction. The higher is the level, the
louder will be the Squelch.
By default, the Squelch level of
G10
is set on level 4.
Make sure you do not set an excessively high squelch level because in this
case you may not be able to receive weaker signals. On the other hand an
excessively low Squelch value could enable the Squelch even when no si-
gnals are present.
Squelch must always be adjusted when no signals are present.
The Time Out timer is settable from 30 sec to 270 sec. only through the
programming software.
This feature is disabled by default.
Battery recharge
G10
is equipped for using a 7,4V Li-ion rechargeable battery pack which
can be recharged connecting the socket of the AC/DC wall adaptor to a
mains power socket and inserting the jack of the wall adaptor into the
desktop charger plug.
It takes 4-5 hours to fully recharge the radio.
For maximum battery life, we recommend charging the battery pack
when the
G10
is off and the battery pack is fully discharged.
