5
E
N
G
LI
S
H
Reconnecting the driver unit to a paired phone
Although you may have previously paired your unit to your phone,
each time you turn one of them off, some phones require that you
re-establish the connection. Reconnecting may also be necessary
when your headset and phone have lost the radio signal because the
distance
between
them
has
exceeded
10
meters.
After you have turned on your mobile phone, there are several methods
to re-establish the connection:
In most cases turning on the driver unit reconnects it automatically
to the phone.
• With some mobile phones you need to re-establish the link to
your headset by using your phone’s menu. Please refer to your
mobile phone’s manual for operating instructions.
• Assuming your mobile phone features voice activation, tap the
CTRL
button on your BT-INTERCOM. This will activate your
voice dial function on the phone, indicating that the connection is
established.
• Do nothing. Once a call is received, answer by tapping the
CTRL
control.
Intercom function
The activation of the Intercom function is very simple: with both units
switched on, the driver or the passenger start talking with the other
party.
To stop using the intercom and return to standby mode (lower current
consumption), stop talking on both sides and the intercom will turn to
standby mode automatically after 15 seconds. When it turns to standby
mode, you will then hear 2 beeps.
The Intercom function uses the AGC technology, that automatically
increases the volume according to the background noise.
Therefore, it may happen that if you try the Midland BT Intercom inside
a silent and close environment, the volume is low but it will increase
while you are on the move on your motorbike!
Intercom always on
The
intercom
function
can
be
activated
by
voice
(Vox)
or
also
manually,
simply short pressing the
Control
button from the passenger unit.
If the intercom is manually activated, the communication between the
driver and the passenger is always open.
•
Shortly press one time the
Control
button to activate the intercom
by
voice
(VOX).
Two
beeps
sound
will
confir
it.
• Shortly press again the
Control
button to activate the intercom
permanently.
A
single
beep
sound
will
confir
it.
The Intercom is factory preset in voice activation (VOX) mode. The
manual activation (always on) can be done only from the passenger
unit. If the passenger unit is switched off or the intercom communica-
tion is closed by an incoming phone call on the Driver unit, the intercom
activation is switched back to the voice activation mode. To activate
again the permanent mode, shortly press the
Control
button on the
passenger unit.
Answering a call when Intercom is active
When the mobile phone rings for incoming call, the Intercom will be
switched
to
stand-by
mode.
To
answer
the
phone
call,
it
is
sufficien
to
pronounce a word or alternatively press the
CTRL
button.
In case you don’t want to answer, remain silent until the phone stops
ringing.
At the end of the phone call, the Intercom will be automatically
reactivated.
On some phones, you will have to wait up to 15 seconds after call
termination before you can return using the intercom again.
To activate the conversation between driver, passenger and
another party
During a phone call, the Intercom is automatically disabled, but
the driver can decided to include the passenger in the phone call
conversation. On the driver unit press shortly the
Intercom
button to
add the passenger to the conversation.
At the end of the call, this feature is automatically deactivates.