Midian SVR-1-KW2, Manual

Page: 11 / 20

11
The unit must be installed and powered-on while making this measurement. Provide the radio the same audio
source and level as in Step 2, generating a 1000 Hz tone and key the radio. Measure the audio level at the
TP1 on the unit.
Programming the Audio Levels:
After determining the audio levels at the audio hookup points, it will be necessary to program the SVR to match
these levels. In the programming software, there is a slider control on the Audio Levels Screen for each of the of
four audio hookup points. Locate the column that corresponds to the modulation and units of measurement for
each of the audio hookup points. Adjust the slider bar such that the value appearing in the appropriate column
matches what was measured as closely as possible. Midian recommends the following values based on 60%
modulation:
Radio Model RX In TX In RX Out TX Out
TK-2170, TK-3170 756 186 786 186