5
Store on COR/Store on VOX:
Select the appropriate method that the unit should use to start recording incoming
audio.
COR Hold-Up Time
This sets the amount of times after a loss of COR or VOX that the unit will wait until it
retransmits the recorded audio.
VOX Settings > Sensitivity:
This is a threshold detection based on the energy level in the audio.
VOX Settings > Attack Time:
This sets the minimum time before the unit will detect VOX based on the sensitivity
setting.
VOX Settings > Decay Time
: This sets the time before the unit will drop the VOX detection. Be certain to set this
long enough so that you do not have drop outs between words or on brief pauses.
Beep Options > Power Up:
Enables a short beep sequence that takes place immediately after power-up.
Beep Options > Error:
This beep may be triggered by any input event if programmed to do so. For example, if a
long press on the Mode Input is not assigned to a function, it may be configured to generate the error beep.
Beep Options > Mode:
Not used as the radio offers its own mode tones for the option board enable.
Beep Options > Go Ahead:
Not currently used.
Beep Options > Wake Up Beep:
Enables a short beep to be sent over the air immediately after PTT is pressed.
Enabling this beep is recommended when the 'Wake on VOX' feature is used. This may also be used to get the
attention of the party receiving a call.
Beep Options > Courtesy Beep:
If selected, once the unit is done retransmitting the recorded audio it will
generate a courtesy tone to let others know it is done retransmitting.
Beep Options > Enable Side Tone Pin:
This box must be checked if the Power Up and Error beeps are to be
used.
