5
PRODUCT PROGRAMMING
Midian’s SVR-1-KW3 is programmed through the radio using the radio’s programming cable (KPG-36 or KPG-46)
and Midian’s MPS programming software. From the product selection screen in the MPS software, select the
SVR-1-KW3 from the list and click OK.
Note:
The radio firmware must be at least 2.00.00.01 and the radio
programming software must be KPG-111D version 2.00 or higher.
Set the parameters of the software to fit the application. If any clarifications on a feature are required, move the
mouse cursor over the feature name until the question mark appears and right click, a definition of the feature will
be shown.
Note:
On the General settings tab the “Program Through Radio Enable” box must be checked.
After entering the parameters, save the file by going to File - Save As. Enter the file name in the File Name block
and click Save. Saving the file will allow for quick and easy reprogramming of units.
Important Note:
Upon entering through the radio programming mode, the unit needs to be read or programmed
within 15 seconds or it will go into sleep mode.
With the radio programming cable connected (KPG-36 or KPG-46) to the radio, press and hold the > button
(Right/Home button) while turning power on to the radio. The radio’s LCD will display “OPT Board Prog”. Select
ProgramUnit or ReadUnit in the MPS software.
