7
SOFTWARE OPERATION
Product Selection:
Select the desired product from the Product Selection screen upon boot up or from the File
menu New Product. Set the parameters of the product as desired then save the file.
Saving a Data File:
Select Save As from the File menu. Click into the File Name box, type the file name and
click Save.
Retrieving a Data File:
Select Open from the File Menu. Browse to the desired file location, select the name of
the file and click Open.
Programming a Unit:
After setting the parameters, save the file before programming the unit. Make certain the
unit is connected as specified above.
The following products must have the PTT button pressed and held before pressing the power button to put the
unit in program mode upon power up.
AE-1, ANI-F, BTD-2, ID-1, PR-1, RD-1, RM-1, RT-2, TDS-1, TDS-3, UD-1B, UE-1, UED-1B, UED-1B-BEZEL
Press and hold the power button and click on program unit within 5 seconds of power up. You will receive a visual
verification of programming on LED D6 depending on the product.
Reading a Unit:
The Program Out function is not supported in the AE-1, BTD-2, ID-1, PR-1, RC-10, RD-1, RD-
10, RM-1, RT-2, TDS-1, UD-1B, UD-1B-DMH, UE-1, UED-1B, UED-1B-BEZEL and UED-1B-DMH. To read a unit
both the Program In and Program Out wires must be connected to the KL-4F. Apply power to the unit and click
on read unit. Note: The ANI-F and TDS-3 must have the PTT button pressed and held before pressing the power
button to put the unit into read mode upon power up.
Upgrade:
Visit
http://www.midians.com/software/MPS/MPS-software.php
for the latest version of the MPS
software.
