12
Problem
Possible Causes
What To Do
Spots and filming
Use Jet-Dry
rinse agent to remove spots and prevent new film buildup.
on glasses and
To remove stubborn spots and pre-existing film from glassware:
flatware
1 Remove all metal utensils from the dishwasher.
2 Do not add detergent.
3 Start the dishwasher and allow to run for 30 minutes. Dishwasher
will now be in the main wash.
4 Open the door and pour 2 cups (500 ml) of white vinegar into the
bottom of the dishwasher.
5 Close the door and allow to complete the cycle. If vinegar rinse does not
work: Repeat as above, Except use 1/4 cup (60 ml) of
citric acid crystals
instead of vinegar.
Cloudiness on
Combination of soft water and
This is called Etching and is permanent. To prevent this from happening,
glassware
too much detergent
Use less detergent if you have soft water. Wash glassware in the shortest
cycle that will get them clean.
Water temperature entering
Lower the water heater temperature.
the dishwasher exceeds 150°F
Black or gray
Aluminum utensils have
Remove marks with a mild, abrasive cleaner.
marks on dishes
rubbed against dishes
Yellow or brown film
Tea or coffee stains
Remove the stain by hand, using a solution of 1/2 cup bleach and
on inside surfaces
3 cups warm water.
CAUTION
Before cleaning interior wait at least 20 minutes after a cycle for the
temperature to cool down. Failure to do can result in scalding.
An overall yellow or brown film can
A special filter in the water supply line is the only way to correct
be caused by iron deposits in water
this problem. Contact a water softener company.
White film on inside
Hard water minerals
To clean the interior, apply dishwasher detergent to a damp sponge.
surfaces
Wear rubber gloves.
Do not
use any type of cleanser other than
dishwasher detergent because it may cause foaming or sudsing. Cascade
Cascade CompleteAnd Electrasol Automatic Dishwashing Detergents
have been approved for use in your dishwasher.
Dishes don t dry
'
Low inlet water temperature
Make sure inlet water temperature is correct (see page 4 ).
Rinse agent dispenser is empty
Check the rinse agent dispenser.
Dishwasher won t
'
Fuse is blown, or the
Replace fuse or reset circuit breaker. Remove any other appliances
circuit breaker tripped
from the circuit.
Steam
This is normal
Steam comes through the vent during washing, drying and when
water is being pumped out.
Extremely hard water
Low inlet water temperature
Overloading the dishwasher
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent
Before you call for service
run
