![background image](http://html1.mh-extra.com/html/midea/rsj-35-300rdn3-b/rsj-35-300rdn3-b_technical-manual_1791197026.webp)
2
nd
Generation ALL IN ONE Type Heat Pump Water Heater Technical Manual
■
It’s normal if some water drips from the hole of PT valve in operation. But, if the water is in a great
amount, call your supplier for instructions.
■
After a long use, check the unit stand and fittings. If damaged, the unit may fall and result in injury.
■
Arrange the drain hose to ensure smooth drainpipe. Incomplete drainpipe may cause wetting of the
building, furniture etc.
■
Never touch the internal parts of the controller.
■
Do not remove the front panel. Some parts inside are dangerous to touch, and a machine malfunction
may be caused.
■
Never expose babies, plants or animals directly to the air flow. Adverse influence to babies, animals and
plants may be resulted.
2. Installation information
■
Enough space is installation and maintenance shall be preserved.
■
The air inlet and outlet should be free from obstacles and strong wind.
■
The bearing surface should be flat, able to bear weight of the unit and suitable for installing the unit
horizontally without increasing noise or vibration.
■
The operation noise and air flow expelled shall not affect neighbors.
■
No flammable gas is leaked nearby.
■
It is convenient for piping and wiring.
CAUTION
■
Installing the equipment in any of the following places may lead to malfunction of the equipment (if it is
inevitable, consult the supplier):
1) The site contains mineral oils such as cutting lubricant.
2) Seaside where the air contains much salt.
3) Hot spring area where corrosive gases exist, e.g., sulfide gas.
4) Factories where the power voltage fluctuates seriously.
5) Inside a car or cabin.
6) Place like kitchen where oil permeates.
7) Place where strong electromagnetic waves exist.
8) Place where flammable gases or materials exist.
9) Place where acid or alkali gases evaporate.
10) Other special environments.
■
Precautions before installation
1) Decide the correct way of conveying the equipment.
2) Try to transport this equipment with the original package.
3) If the unit has to be installed on a metal part of the building, electric insulation must be installed, and the
installation must meet the relevant technical standards for electric devices.
■
Installation
space
Before installing the unit, reserve the space of maintenance .
WARNING
■
Ask your supplier to install the air source heat pump water heating units. Incomplete installation
performed by yourself may result in a water leakage, electric shock, or fire.
■
The place without direct sunlight and other heat supplies. If there’s no way to avoid these, please install
a covering.
27
Summary of Contents for RSJ-35/300RDN3-B
Page 14: ...2nd Generation ALL IN ONE Type Heat Pump Water Heater Technical Manual E HEATER MODE 15...
Page 16: ...2nd Generation ALL IN ONE Type Heat Pump Water Heater Technical Manual 4 Dimensions 17...
Page 19: ...2nd Generation ALL IN ONE Type Heat Pump Water Heater Technical Manual 7 Piping Diagrams 20...
Page 21: ...2nd Generation ALL IN ONE Type Heat Pump Water Heater Technical Manual 9 Exploded View 22...