W
Alternative method of installation if external
support cannot be provided.
FLASH OR SEAL AROUND EXTERNAL
WALL FRAME OR ARCHITRAVE
STURDY TIMBER
FRAME
TIMBER FRAMED
ALL OR PARTITION
SOLID TIMBER SUPPORT
STEADYING BRACKET
(ONE PER SIDE)
DRAIN PAN
ENSURE LOUVRES
ARE ENTIRELY
OUTSIDE THE WALL
Step 1
Slide the unit into the housing until it is firmly against the
rear of the housing. Care is required to ensure the foam
sealing strips on the housing remain in position.
Step 2
Connect the air conditioner to the power and position the
excess cord length beneath the air conditioner base.
Step 3
Engage the chassis fixing brackets into the bottom housing
rail and secure to the base with the screw
provided.
Step 4
Remove the front panel from it’s carton and plastic bag and
fit as per the Installation Instruction.
Step 5
Switch unit on. Check for operation of the unit and check for
vibration in the installation.
Step 6
Fit the drain pan to the housing and run a drain line to a
suitable location if required.
AIR IN
AIR IN
AIR OUT
100mm minimum
OPTION A
AIR IN
LOUVRE
BRICK
WALL
O
45 BRICK CUT AWAY
TO CLEAR LOUVRES
FRONT
AIR OUT
AIR IN
AIR IN
TOP
VIEW
O
45 BRICK CUT AWAY
TO CLEAR LOUVRES
100mm
BRICK
WALL
100mm
OPTION B
Installations of the unit into the wall
Installations of the unit into the housing
Step 4. Install the frame
Fix the screws on the frame (See Fig.3).
Step 5. Install the air filter and front panel
a. Install the air filter into the frame’s slot from upside to underside
(See Fig.2).
b. Hang the front panel on the frame’s buckle, then press the front
panel into the frame’s slot until you hear a click (See Fig.10).
6
4
5
Installations steps
Step 1. Remove the front panel and the air filter
a. Hold the slot under the front panel, then uplift it outwards, and remove the front panel (See Fig.1).
b. Pinch the handle under the air filter and make the air filter arched, remove it from the slot from
underside to upside (See Fig.2).
Step 2. Remove the frame
a. Remove the two fixing screws from the frame (See Fig.3).
b. Grasp the left corner of the frame’s underside, release the coupler plugs, then loosen the frame
(See Fig.4).
Step 3. Installation
a. Remove the two fixing screws on the chassis fixing brackets, then remove the chassis fixing brackets
(See Fig.5).
b. Grasp the handle on the chassis and carefully slide the air conditioner out of the cabinet (See Fig.6).
c. Remove shipping pad from around compressor before operation and make sure the discharge points
to the
15
16
