5
OPERATING INSTRUCTION
[Inspection before start]
(1) The power cord shall not be damaged or fractured.
(2) This machine uses 220-240V AC power so please verify the rated current of the
power socket is in line with the requirements in the table above and is equipped
with a safety grounding device before use; otherwise, replace the socket.
[Start and power selection]
1. Start
Plug in the power, clockwise turn the thermostat knob to the "MAX" mark position,
then turn on the power switch, the heater starts to work.
2. Power selection
Under normal circumstances, please use the maximum power "HI" gear for rapid
heating. If the room temperature reaches a suitable temperature, please choose a
lower power "MED" or "LO" gear to reduce energy consumption so as to prevent
the room becoming overheated.
Note: To use the machine for the first time or to re-insert the socket, please pay
attention to check whether the plug and the socket are fitted well.
Inspection method: Insert the power plug into the socket and start for use; after
about half an hour, turn off and pull out the plug. Check whether the plug pins are
hot; replace the socket if so (more than about 50 °C) to avoid burning the plug or
even causing a fire caused by overheating of the socket due to poor contact.
[Temperature adjustment]
During use, if you feel it is necessary to lower the room temperature since it is too
high, you can use the following adjustment modes:
(1) Turn the power switch to gear "MED" or "LO".
(2) Counterclockwise turn the thermostat knob back by a certain angle, for which it
indicates that the set temperature is lower when the temperature indication is
closer to the "MIN" position.
[Fan function]
Press the fan switch to the "ON" position so that the fan heater starts working and
the room temperature will rise rapidly.
Note:
a. If the room temperature is below the set temperature, the indicator light will be
always illuminate.
b. The room shall be sealed; otherwise, the heating effect will be affected.
[Stop]
Turn the power switch to indication point "0FF", and then pull out the power plug.
[Movement of the heater]
To move the heater, turn it off first, and pull out the power plug; then push the body
to make the four casters below the body to roll.
