1.
To ensure familiarity with the controls, safety features, and
operation of your heater. Read all instructions before using.
2.
To reduce hazard of injury due to electric shock.
2.1 Danger of shock exists even when the appliance is switched off.
ALWAYS unplug when not in use.
2.2 A heater should never be used under conditions where it may
be immersed, or come in contact with water. Similarly do not
plug in your heater if its surfaces are damp.
2.3 Do not insert foreign objects through the intake or discharge
grilles.
2.4 Do not operate the heater if the cord was damaged in any
manner. Return it to an Authorized Service facility for inspection,
repairing and testing.
2.5 Close supervision is required when any appliance is used by or
near children.
2.6 Shut the power off before cleaning.
2.7 Unplug by grasping plug and pulling it from the outlet. NEVER
YANK ON CORD.
2. 8 When storing your heater, keep it in a cool, dry place.
2. 9 An electrical supply of 230 volts AC only, 50Hz is required.
Make sure that the plug is fitted in a suitable electrical supply
socket. Never use with an extension cord if the plug cannot be
fully inserted. Do not attempt to defeat this safety feature.
3. To reduce hazard of injury or property damage due to heat, fire,
or explosion:
3.1 Position your heater away from furniture or loose hanging
materials. Do not drape clothing or towels, etc. over the
heater to dry.
3.2 Keep the rear grille out from walls or drapes so as not to block
the air intake.
3.3 Use of an extension cord is not recommended. However, if it is
absolutely necessary ensure the cord is short as possible (long
cords coiled up can overheat, as well as cause tripping accidents)
and NOT USED TO SUPPLY POWER TO MORE THAN ONE
APPLIANCE AT A TIME.
3.4 Do not use in the presence of explosive or flammable vapors.
3.5 Do not run in locations when the heater will be left unattended
for long periods of time. (for example
g
several weeks in an
unoccupied summer cottage).
3.6 Use the heater on flat, dry surfaces only.
3.7 LOOSE CONNECTIONS BETWEEN THE HEATER PLUG AND THE
ELECTRICAL OUTLET MAY CAUSE THE PLUG TO OVERHEAT.
REPLACE ANY WORN ELECTRICAL RECEPTACLES PROMPTLY.
3.8 Use on 230-volt 50Hz AC power supply.
3.9 ENSURE NO OTHER APPLIANCES ARE PLUGGED INTO THE SAME
CIRCUIT AS YOUR HEATER. A CIRCUIT OVERLOAD COULD
OCCUR, RESULTING IN DIMMED LIGHTS, BLOWN FUSES,
TRIPPED CIRCUIT BREAKERS, OR FIRE HAZARD.
3.10 Route the cord so that it will not be walked on, or pinched by
furniture.
3.11 This product is intended for normal household use only.
4. AIR FILTER MUST BE USED.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
1. Plug into any 230V, 50HZ, and AC source. (See important
safeguards section 3.3 regarding use of extension cords).
2. Your heater is equipped with a 4-position control switch.
SYMBOL
FUNCTION
OFF
SHUT OFF POWER
LOW
APPROX—1000 WATTS
HIGH
APPROX—1500 WATTS
3. Set the control switch to maximum (HIGH) for fast warm up of a
room. Once the room is comfortable, select a lower setting to
reduce electrical consumption and to prevent the room from
