Easy assembly
7
6
Product Operation
Slide battery onto hand vacuum
until firmly attached (Fig. 1).
01
Slide wand onto hand vacuum
until it clicks (Fig. 2).
02
Push wand into motorized floor
nozzle until it clicks (Fig. 3).
03
How to install wall mount
Choose location near power outlet.
Locate point high enough on wall to
allow wand and motorized floor
nozzle to hang freely.
01
Place mount against wall and use
pencil to mark drill holes.
02
Drill holes (with 1/4" bit) and insert
drywall anchors. Insert screws
through holes on mount and tighten
until firmly attached (Fig. 4).
03
How to charge battery
and store accessories
Place assembled vacuum cleaner
on wall mount.
01
Plug charger into power outlet and
then into charger port on handle
(Fig. 5).
02
Loop charger cord into clips on
sides of wall mount.
03
Snap tool(s) into tool storage areas
(Fig. 5).
04
Battery indicator lights show
level of charge
(Fig. 5):
A. Fully charged
B. Half charged
C. Low power
•
Indicator lights stop blinking when
fully charged.
•
Charge battery fully before using for
the first time. This may take up to
four hours.
1
2
3
4
5
Click!
Click!
Drywall anchors
Cord
clip
Cord
clip
Tool storage Tool storage
How to use cleaner for cleaning floors
Click power button once to start.
01
Using motorized floor nozzle, glide back and forth on area to be cleaned. Avoid oversized or sharp
items (such as screws) with cleaner.
02
Twist wrist to engage swivel function.
03
When done, click power button once to stop motor.
04
Power button
Empty dust cup after every use
There are two ways to empty the dust cup:
Hold cleaner over waste basket. Press lever to release bottom lid of dust cup to empty debris.
01
Remove dust cup from hand vacuum by twisting to 'unlock' position. Once emptied, reattach dust
cup by lining up arrow and 'unlock' position. Twist dust cup until arrow lines up with 'locked'
position.
02
C B A
