Midea MPF08CR71, User Manual

Page: 27 / 32


Page 26

Oper
ating
Ins
tructions
(W
ith R
e
m
ot
e
)
How to Use Use the Advanced Fuctions
SHORTCUT Function
SWING Function
Note:
ON/OF F
T E MP
SHORT
CUT
TIMER
ON
TIMER
OFF
MODE
FAN
LED
ION
SLEEP
FOLLOW
SWING
ME
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the sa
m e te m perature settings to stay
co m fortable). This function can only be
activated via re m ote control.
Used to stop or start louver m ove m ent and set the
desired up/down air flow direction. The louver
changes 6 degrees in angle for each press (so
m e
m odels without). If keep pushing m ore than 2
seconds, the louver auto swing feature is activated.
The FOLLOW ME function enables the
re
m ote control to m easure the
te m perature at its current location.
When using AUTO, COOL, or HEAT
functions,
m easuring a m bient
te m perature fro m the re m ote control
(instead of fro m the indoor unit it self)
will enable the air conditioner to
opti
m ize the te m perature around you
and ensure m axi m u m co m fort.
1. Press FOLLOW ME button to activate
function. The re m ote control will send
te m perature signal to the unit every
three m inutes.
2. Press FOLLOW ME button again to
turn off this function.
Used to restore the current settings or resu m e
previous settings.
Push this button when re m ote controller is on,
the syste m will auto m atically revert back to the
previous settings including operating m ode,
setting te m perature, fan speed level and sleep
feature (if activated).
If pushing m ore than 2 seconds, the syste m will
auto m atically restore the current operation
settings including operating m ode, setting
te m perature, fan speed level and sleep feature
(if activated).
The SLEEP function is not
available in FAN or DRY mode.
FOLLOW ME Function
NOTES
• Buttons design is based on typical model and might be slightly different from the
actual one you purchased, the actual shape shall prevail.
• All the functions described are accomplished by the unit, if the unit has no this
feature, there is no corresponding operation happened when press the relative
button on the remote controller.