4
water inlet (water pressure:0.1-0.4MPa)
cold water
tank
ambient water outlet
cold water outlet
hot water outlet
hot water
tank
drain water
UF
mem-
brane
filter
2-5 Working principle
1. Flowchart of water generation
2. Circuit diagram
PP
fibre
filter
reducing
valve
solenoid valve
solenoid valve 1
display board
power board
N
bimetal 1
bimetal 2
heater
compressor
N
HEAT
COOL
L
L
PE
Front
active
carbon
filter
Post
active
carbon
filter
Function
Filter
Stage
Stage 1
Stage 2
Stage 3
Stage 4
3. Filter Function Introduction
PP fibre filter
UF membrane filter
Post active carbon filter
Front active carbon filter
Carry out coarse filtration of original water, and filter out
mud, sand, impurity, iron rust and suspension, etc
Absorb unusual colors and odors, Remove residual
chlorine and organic substances in water
Further absorb micro-molecules and organic substances
in water. Make water taste better
Remove bacteria, iron rust, colloids and impurities in
water
3. Use Guide and Maintenance
WARNING:
Please cut off water source before replacing filters. Never plug filters in water running
state.
3.1 Guidance on Unpacking and Installation
1. Open the top of the packing case, take out the top foam and its accessories.
2. Put the accessories aside.
3. Unpack the product, install the water collector.
4. Take out the quick joint, and install it on the water pipe.
3/4" internal screw thread
1/4" PE pipe connector
PE pipe
Tap water