Maintenance of show cases
Cleaning
show case shall be manually defrosted.
Unplug the show case and open the show case door, remove foods and drawers before defrosting;
Open the outflow holes and drainage holes (and place water container at the outflow holes);
indoor frost will naturally melt, wipe the defrost water with a dry, soft cloth. When the frost
softens, an ice scraper might be used to the accelerate de-icing process.
Please remove the food and put in a cool place when defrosting before removing accessories.
Foods can be preserved for a couple of hours even in summer in case of power failure; it is
recommended to reduce the frequency of opening door and do not put fresh foods into the
show case.
Please unplug the show case left unused for a long time for cleaning. Keep the door open to avoid
the bad odor.
Do not turn upside, horizontally place or vibrate the refrigerator, the carrying angle can not be
greater than 45
°
. Please hold the door and hinge when moving.
Do not use hard brushes, clean steel balls, wire brushes,
abrasives, such as toothpastes, organic solvents (such as
alcohol, acetone, banana oil, etc.), boiling water, acid or
alkaline items clean refrigerator considering that this may
damage the fridge surface and interior.
Do not rinse with water so as not to affect the electrical insulation
properties. Please use a dry cloth when cleaning temperature
control knob and electrical components.
Please unplug the
for defrost and cleaning.
show case
Dusts behind the show case and on the ground shall be timely cleaned to improve the cooling
effect and energy saving. The interior of the show case should be cleaned regularly to avoid odor.
Soft towels or sponge dipped in water and non-corrosive neutral detergents are suggested for
cleaning. The show case of shall be finally cleaned with clean water and dry cloth. Open the door for
natural drying before the power is turned on.
Defrost
Other mechanical devices or other means shall not be used to accelerate
except those recommended by the manufacturer. Do not damage the
refrigerant circuit.
Stop using
Continuous operation is recommended when the show case is
started. Please do not move the show case under normal
circumstances so as not to affect the show case's service life.
6
