Placement
Start
Proper use of show cases
The show case is placed in a
well-ventilated indoor place;
the ground shall be flat, and
sturdy .
Before using the show case,
remove all packaging
materials including bottom
cushions and foam pads
and tapes inside the show case,
tear off the protective film
on the door and the show case
body.
Keep away from heat and
avoid direct sunlight. Do not
place the show case in moist or
watery places to prevent rust
or reduction of insulating
effect.
The top space of the show case
shall be greater than 70cm, and
the distances from both sides
and backside shall be more than
20cm to facilitate the opening
and closing and heat dissipation.
Wipe the show case inside and
outside with warm moist rag
(add a small amount of detergent
in the warm water and wipe clean
finally with clean water).
The show case shall stay for half an hour before connecting
220~240V/50Hz power when it is firstly started.
The show case shall run 2 to 3 hours before loading fresh or
frozen foods; the show case shall run for more than 4 hours in
summer in advance considering that the ambient
temperature is high.
5
Temperature Control
Connect the show case to power.
0
0
The temperature
（
about10 C
～
1 C
）
of the chamber is adjusted through the thermostat knob
The user can choose the right temperature zone according to their needs.In the same
environment temperature,the lower the number is, the higher the temperature inside will
be and verse versa."0
”
position stands for not in operation. The number of the thermostat knob
do not mean a specific temperatures.Generally, the knob of temperature controller shall be
turned to grade 3-5 during use.
。
，
5
7
6
0
4
3
2
1
Temperature Control
It is a normal phenomenon that there is condensation water on
the surface of glass and the top of outlet housing during use,
mop it with dry cloth.
