Midea C5 PRO, Operation & Instruction Manual

Page: 5 / 10

维护保养
尘杯维护保养
Dust cup maintenance
Product Maintenance
9 8
01
. 打开尘杯：轻提尘杯开启按钮，然后向上提起即可打开尘杯盖。
02
. 取出过滤棉清洁：打开尘杯后取出过滤棉并清洁即可。
清洁过滤棉
Open the dust cup
Clean the filter cotton
打开尘杯
各过滤部件清洗后必须干燥后才可装回使用，建议阳光下晒24小时确保彻底干燥后再使用；必须确保各
部件安装到位，否则会引起产品故障；不可将水渗入吸尘器电器元件内，否则可能会引起产品故障。
注意
Caution
03
. 过滤芯拆卸，过滤芯清洗：向上提出滤芯并拆下滤芯下盖，将过滤芯、过滤芯下盖放在水龙头下冲洗。
Filter disassembly and cleaning : Raise the filter and remove the filter cover, put the filter and its
bottom cover under the faucet for washing.
04
. HEPA清洗：按图示打开出风板，取出HEPA后清洗即可。
HEPA cleaning : Open the air foil as shown in figure below, and clean after removing the HEPA.
Take out the filter
and clean
取出过滤芯并清洁
a b
Open the dust cup : Gently lift the dust cup openbutton, and then lift up to open the dust cup cover.
Remove the filter cotton and whirlwind cone. clean the whirlwind cone and beat the filter cotton down.
（Do not beat along the reverse).
The filter parts can be put back for use only after being cleaned and dried. It is recommended to have
sun exposure for 24 hours to ensure it is thoroughly dried. All parts must be ensured to be properly
installed, otherwise it will cause product failure. Water is not allowed to penetrate into the vacuum
cleaner electrical components, or otherwise may cause product failure.