In case of abnormalities such as abnormal noises, smell, smoke, etc., you should
immediately cut off power and stop use.
If the product cannot work, please check if the power supply is connected, if the
switch is put to the ON position and if fittings are installed in place.
If the product still cannot work after checks mentioned above, please consult the
designated repair centre for maintenance.
ABNORMALITY ANALYSIS AND HANDING
Abnormality Handling
Fault Analysis and Elimination
1.
2.
3.
The appliance is not
working
Appliance not plugged in
Wall outlet not energized
Appliance not switched on
Overheated appliance
Over current protection
activated
Too much food in the jar
Malfunctioning appliance
Insert the plug into the wall outlet
Check fuses and circuit breaker
Turn the control knob to the ON position to
place the appliance in standby mode. Indicator
Turn the control knob to the OFF position,
unplug the appliance from the wall outlet and
allow to cool down before using it again
Turn the control knob to the OFF position
to switch the appliance o , then to the ON
position to place the appliance in standby
mode. Resume blending operation
Turn the control knob to the OFF position,
remove some food, shake ingredients to
redistribute and restart blending operation
Turn the control knob to the OFF position,
unplug the appliance from the wall outlet and
check and repair
the appliance
The blades are
rotating very slowly
Too much food in the jar /
Motor is overloaded
Not enough liquid in the jar
/ Motor is overloaded
Turn the control knob to the OFF position,
remove some food, shake ingredients to
redistribute and restart blending operation
Turn the control knob to the OFF position,
add some liquid and restart blending operation
Food not fully
blended
Ingredients too large
Too much food in the jar
Turn the control knob to the OFF position,
remove ingredients and cut them into smaller
pieces
Turn the control knob to the OFF position,
remove some food, shake the jar to
redistribute the ingredients and then restart
blending operation
Water leakage
Parts not tightly secured
Missing seal ring on the lid
Damaged seal ring on the
lid
Damaged seal ring on the
blade unit
Check and secure the parts carefully
Place the required seal
Replace with a proper new seal
Replace the blade unit
Problem
Cause
Solution
7