5
IMPORTANT
Adding a menu program to the oven will overwrite an existing program. DO NOT enter a new menu program over an existing
program that you wish to keep!
1. Restore power to the oven at the circuit breaker/fused disconnect.
2. Switch the Power On/Off (I/O) Switch to the ON (I) position.
E. PROGRAMMING PRESET MENU SELECTIONS
4.
CHOOSE A MENU
SELECTION TO
PROGRAM
Press and hold
(or any other preset menu key) until
appears in the display. The
number in the display (1 is shown above) will match the menu key that was pressed (1-5).
5.
SET TOP TEM-
PERATURE
6.
SET BOTTOM TEM-
PERATURE
a. Press
. The current top set temperature appears in the display.
b. Press
and
as necessary to change the displayed temperature.
Pressing
once increases the active (flashing) digit by one. This digit rolls over to its
minimum value if
is pressed when the digit shows its maximum value.
Pressing
once causes the next digit to the right to become the active (flashing) digit.
If the far-right digit is flashing when
is pressed, the far-left digit will flash and become
the active digit.
IMPORTANT
The allowed temperature range is 200-599°F (93-315°C). If you program a set temperature between
0°F (or 0°C) and 99°F (37°C), the heater will be set to OFF. If you program a set temperature
between 100°F (38°C) and 199°F (92°C), the temperature will automatically change to 200°F (93°C),
the display will flash, and a beep will sound to alert you to the temperature change.
a. Press
. The current bottom set temperature appears in the display.
b. Press
and
as necessary to change the displayed temperature.
IMPORTANT
It is recommended that the top and bottom zone temperatures be set WITHIN 50°F (28°C) of each
other. Greater temperature differences may result in the hotter zone heating the cooler zone. This
can cause inconsistent cooking results.
a. Press
. The current cook time appears in the display (minutes : seconds).
b. Press
and
as necessary to change the displayed time.
IMPORTANT
The allowed cook time range is 00:30-15:00. If you program a cook time outside of this range, the
time will change to the closest allowed time (00:30 if your time was too short, or 15:00 if it was too
long). The display will flash, and a beep will sound to alert you to the changed cook time.
8. Press ONE of the following keys:
,
, or
: Re-enter the top setpoint temperature, bottom set point temperature, or cook time.
: Turn off Programming Mode. This returns the oven to normal operation.
Any other key except
or
: Resume operation, but leave Programming Mode active. Other Preset Menu
Selections can be programmed at this time.
3. Press and hold
until
appears in the display.
7.
SET COOK TIME
