Middleby Marshall PS360E Series, Owner'S Operating & Installation Manual

Page: 28 / 60

SECTION 2
INSTALLATION
28
Conveyor Installation
1. Unfold the conveyor as shown in Figure 21. Then
begin to slide the conveyor into the end of the
oven. The conveyor can only be installed from the
side of the oven where the drive motors are
located.
2. Continue moving the conveyor into the oven until
the frame protrudes equally from each end of the
oven. Check that the crumb tray supports located
on the underside of the conveyor frame rest firmly
against the lower end plugs, as shown Figure 22.
3. When the conveyor is positioned properly, check
for freedom of movement of the conveyor belt by
pulling it for about 2 to 3 feet (0.6- 1.0 m) with your
fingers. The drive and idler shafts must rotate
smoothly, and the belt must move freely without
rubbing on the inside of the oven. If not, then re-
align the belting.
4. Check the tension of the conveyor belt as shown
in Figure 23. The belt should lift about 1" (25mm).
DO NOT OVER TIGHTEN THE CONVEYOR
BELT.
NOTE: If necessary, the belt tension can be adjusted
by turning the conveyor adjustment screws, located at
the idler (non-control) end of the conveyor. See Figure
23.
Conveyor Installation
Conveyor Placement
Conveyor Belt Tension