Page 6
1) Route Temperature Probe, Alarm Output, and Power Supply wires along the rear of the
panel as shown above. Tie points are provided to route wires left or right. Do not allow wires
to interfere with fan operation.
2) Using tie saddle included, mount the temperature probe wire into highest available area inside
of rack. In order to achieve proper temperature sensing, the probe should be installed near
the top of the rack. The probe is provided with a generous 9' lead.
WIRE TIE HERE
WIRE TIE HERE
CONTROL SETTINGS
Press once to view the current
overtemp alarm setting.
Each additional push will raise
the overtemp alarm setting
by 1
O
.
To toggle between Fahrenheit
and Celsius, press and hold for
3 seconds.
OVER
TEMP
ALARM
(N.O.)
5VDC
2A
FAN
FAULT
ALARM
(N.O.)
PUSH
CONTROL SETTINGS
Press once to view the current
overtemp alarm setting.
Each additional push will raise
the overtemp alarm setting
by 1
O
.
To toggle between Fahrenheit
and Celsius, press and hold for
3 seconds.
OVER
TEMP
ALARM
(N.O.)
5VDC
2A
FAN
FAULT
ALARM
(N.O.)
PUSH
TIE SADDLE
TEMPERATURE PROBE
INSTALLATION
UQFP-2D (left) & UQFP-4D (right) Shown.
TECH TIP: Ensure that you have access to the rear of the panel to make connections and
configure settings once mounted. If access to rear of unit is limited, cable management and
setting configurations must be done prior to mounting the panel.
3) (220V models only) Select appropriate wall plug for your region and attach to
provided power supply. Connect power supply to power source.
