1. Install the mounting clips through the infinite or fixed
position holes in a Middle Atlantic Product enclosure
as shown. (
FIGURE B
)
2. Insert the PDU by gently tapping with the palm
of your hand.
TIP
: To remove the PDU from the mounting clips,
wedge a flat head screwdriver between the side of the
PDU and clip, and gently pry the PDU from the clip as
shown. (
FIGURE C
)
FIGURE C
FIGURE A
FIGURE B
Infinite
Positional
Slot
Ferrite
Rackrail
Mounting
Bracket
PDU
Screwdriver
Tip
Clip
Nut
Fixed
Mounting
Position
Screw
Mounting
Clip
RACKLINK HARDWARE SETUP
Page 4
1.
Install the device in the location it will
reside.
2. Plug the device into a properly
grounded AC power source.
3. Connect the device to your network
using a shielded Cat 5 cable, or
better.
4. Attach the ferrite provided (part
number: 600-01660) as close as
possible to the connector going into
your device on your shielded Cat 5
cable. (
FIGURE A
)
NOTE
: The following hardware setup instructions apply to vertical (RLNK-1015V and RLNK-1615V) and
the compact (RLNK-215) models only.
Installing Vertical (RLNK-1015V and RLNK-1615V)
Models in an Enclosure
WARNING
: For safety instructions, refer to the “Select Series PDU with RackLink User Manual” at
www.middleatlantic.com/downloads
.
AVERTISSEMENT
: Pour obtenir des instructions de sécurité, reportez-vous à la "Select Series PDU
with RackLink User Manual" à www.middleatlantic.com/downloads.
Summary of Contents for RackLink RLNK-1015V
Page 8: ......