Midas APOLLO QA018, Mounting Instruction

Page: 5 / 25

4
MIDAS Group 2020
2 1
aluminium upper
sliding sheet
door glass 3
7
6
aluminium lower
sliding sheet
4
5
Lower roll
SEALING OF SIDE FIXED GLASS IN ALUMINIUM PROFILES (VERTICAL
PROFILES)
Depending on the type of cabin, various types of gaskets may be found between
the vertical profile and the fixed glass.
If the cabin set you have purchased
contains “U”-shaped gaskets:
place them on the longer edge of the fixed glass and insert inside the vertical
profile.
If the cabin set you have purchased contains
„A”-shaped gaskets: once you insert
the glass into the profile, gently drive the gasket into the gap in between the glass
and the profile.
NOTE! Driving the gasket must be performed with the use of a smooth
element to prevent surface scratching of glass.
ASSEMBLY OF ROLLS IN ALUMINIUM SLIDING SHEETS
1. Mount upper rolls to two upper holes located in the glass wing of the door and
similarly, mount lower rolls to the lower holes (lower rolls have a button enabling
the release of glass from the sliding sheets).
2. Screw the rolls by means of screws [2] and [5].
3. Insert upper rolls in the upper sliding sheet track.
4. Pressing the button [6] on the lower roll causes moving of the roll's wheel [4].
5. After pressing the button, enter lower rolls into the lower sliding sheet track.
6. After releasing the roll's pressure, they should zip on the sliding sheet.
7. Regulate the door settings by means of screws [3] and [7]
upper roll
While regulating the sliding glass doors, maintain special caution. Glass doors
must tightly adjoin to each other after closing them and the sliding cannot be
hindered, otherwise you must regulate the screws that fix the rolls or check if
magnetic gaskets are placed in the right way.
!